How to Understand and Use the Arrhenius Equation
At a glance
- 1. Write the equation
Relate the rate constant to temperature, the activation energy, and the pre-exponential factor.
- 2. Use kelvin
Convert temperatures to kelvin and keep energy units consistent with the gas constant.
- 3. Choose a calculation
Use one-temperature data, two-temperature data, or a plot of logarithmic rate constants.
- 4. Check assumptions
Interpret the result over a range where the reaction mechanism and Arrhenius behavior remain valid.
The Arrhenius equation describes how a chemical reaction’s rate constant changes with temperature. It is useful for estimating how much faster a reaction will become when warmed, or for finding an apparent activation energy from rate measurements. The equation is empirical, but its exponential form has a useful molecular interpretation.
The Arrhenius equation
The usual form is
Here, is the reaction’s rate constant, is the pre-exponential factor (also called the frequency factor), is the activation energy, is the molar gas constant, and is absolute temperature in kelvin. If you use , express in joules per mole. Alternatively, use with in kilojoules per mole.
The units of are the same as the units of . Those units depend on the reaction-rate law: for example, a first-order rate constant has units of inverse time, while a second-order rate constant commonly has units of concentration-inverse time.
As increases, the exponent becomes less negative, so increases. In a simple molecular picture, more molecules have enough energy to reach a reactive configuration. The parameter accounts for factors such as collision frequency and the likelihood that collisions have a productive orientation. This picture is helpful, but the Arrhenius equation is usually applied as a model fitted to experimental data.
Calculate a rate constant at one temperature
If and are known, substitute them along with the temperature in kelvin. For instance, suppose a reaction has , , and you want at . Use :
This gives the rate constant, not automatically the reaction rate. To find the rate, you also need the rate law and the concentrations. For a first-order reaction, for example, .
Estimate activation energy from two temperatures
If you know the rate constants at two temperatures, divide the Arrhenius equation at one temperature by the equation at the other. Taking natural logarithms gives
Therefore,
For a concrete example, let at and at . Then
This is an apparent activation energy based on those measurements. The calculation assumes the same reaction pathway and rate-law regime apply at both temperatures.
Use an Arrhenius plot
Taking the natural logarithm of the equation gives a straight-line form:
Plot on the vertical axis against on the horizontal axis. If the data follow Arrhenius behavior, a linear fit has slope and intercept . Thus , and . If the horizontal axis is instead , account for the factor of 1000 when converting the slope to .
A fit using several measurements is generally more informative than a two-point estimate, because it shows whether the data are approximately linear and reduces reliance on any single measurement. Use the same logarithm convention throughout: the equations above use the natural logarithm, . A base-10 plot has a different slope, with the factor included in the conversion.
Common mistakes
- Using Celsius: Convert to kelvin first: . Do not put Celsius values into the equation.
- Mixing units: Pair in joules per mole with , or pair kilojoules per mole with .
- Reversing the temperature terms: In the two-temperature formula, keep the order consistent with the rate ratio. If and , the calculated should be positive.
- Confusing with rate: The Arrhenius equation predicts how the rate constant depends on temperature. The reaction rate also depends on reactant concentrations.
- Assuming every reaction stays linear: Changes in mechanism, phase, or other conditions can cause departures from a straight Arrhenius plot. A fitted activation energy may then depend on the temperature range.
References
- Physical Chemistry, 11th edition — Peter Atkins, Julio de Paula, and James Keeler
- Chemical Kinetics, 3rd edition — Keith J. Laidler
Spotted an error? Send a correction. Read how we write and check articles in our editorial policy.