How to Square a Taylor Series
At a glance
- 1. Write the series
Express the function as powers of x minus the expansion point.
- 2. Use the Cauchy product
Multiply coefficients whose indices add to the desired power.
- 3. Collect each coefficient
The coefficient of the nth power is a finite convolution sum.
- 4. Check the result
Compare with known identities or differentiate the squared function directly.
A phrase such as “Taylor expansion square” usually means finding the Taylor expansion of when the Taylor expansion of is known. The correct operation is not to square each coefficient separately. Instead, multiply the series and collect powers of .
If the question literally concerns the Taylor expansion of , then about the answer is simply : it is already a polynomial, so all Taylor coefficients above degree two are zero. About a general center , the same polynomial written in powers of is
The general rule
Suppose has a Taylor series about :
Squaring gives
The coefficient of comes from every pair of terms whose powers add to . Therefore,
where
This coefficient formula is called the Cauchy product of the two power series. For the square, it is a convolution of the coefficient sequence with itself.
Writing out the first terms makes the pattern clear:
Worked example: squaring the exponential series
Find the Taylor series about for by squaring the Taylor series of .
The exponential series is
The coefficients are . Using the Cauchy product, the first terms of the square are
Since , its Taylor series is also
This gives
which confirms the multiplication.
In fact, the coefficient identity behind this example is
Worked example: squaring a sine series
The Maclaurin series for sine is
To calculate through degree six, retain enough terms and multiply:
The same result follows from the identity
Using the cosine series produces
Notice that only even powers appear. This is expected because is an even function.
An alternative method: differentiate the square
You can also calculate the Taylor coefficients directly from the function . The Taylor expansion about is
For the first few derivatives,
Higher derivatives can be found with the product rule, although this becomes cumbersome. The Cauchy product is usually faster when the Taylor series of is already known. Direct differentiation is useful when is simple but its series is not yet available.
Expansion about a nonzero point
The method does not depend on expanding about zero. For example, suppose
Then
The coefficient of is obtained from
Common mistakes
Squaring each coefficient
In general,
For instance, the coefficient of in the square is , not .
Forgetting cross terms
When multiplying truncated series, terms such as and must be included. They are often the source of incorrect coefficients.
Truncating too early
To find the square through degree , you need all terms of through degree . A term of degree multiplied by one of degree contributes to the answer.
Ignoring convergence
For a power series with radius of convergence , the Cauchy product equality certainly holds for , where the series converge absolutely. Behavior on requires separate analysis. The resulting squared power series can sometimes have a larger radius of convergence if singularities disappear upon squaring, but an independent analytic continuation of beyond that disk is not, in general, the same as the original Taylor series converging there.
References
- Calculus, Volume II — Tom M. Apostol
- Mathematical Analysis — Walter Rudin
Spotted an error? Send a correction. Read how we write and check articles in our editorial policy.